How to Make Your Lace Melt

Why lace does not melt

Nine times out of ten it is one of three things: the lace is too dark or too light for your skin, the adhesive was applied too thickly, or the lace was not held down long enough while it set.

Step 1 — Match the lace to your skin

Use HD or transparent lace and tone it lightly with a spray tan mist, foundation on a damp sponge or a tinted lace spray from underneath. Build up slowly — lace that is too dark looks like a shadow at the hairline.

Step 2 — Clean the canvas

Wipe your hairline with rubbing alcohol to remove oil, then apply a thin scalp protector. Adhesive grips clean, matte skin.

Step 3 — Thin layers only

Two to three thin layers of adhesive, each allowed to go tacky before the next, hold better and sit flatter than one thick coat. Press the lace with the flat back of a comb rather than your fingertips so you do not leave ridges.

Step 4 — Band and spray

Wrap an elastic band along the perimeter, spritz melting spray generously across the lace, and leave it 10 to 15 minutes. This is the step most people cut short — the wait is what does the melting.

Step 5 — Set and finish

Remove the band, part out your baby hairs, swoop them with a little edge control and a toothbrush, then blast the front with cool air. Finish with a light dusting of translucent powder or setting spray to kill any shine.

Refreshing without re-gluing

Mid-week lift is normal at the temples. Add a small amount of adhesive only where it lifted, band and spray again — do not re-glue the whole front.

Removal

Always use a proper adhesive remover, let it break the bond fully, and lift the lace slowly from the ear tabs inward.